Hitachi Deskstar E7K500 Install Manual

Hitachi Global Storage Technologies

Quick Installation Guide

Hitachi Deskstar
Serial ATA 3.0Gb/s Hard Disk Drive
Model: HDS725050KLA360
System Requirements for Serial ATA
_______________________________________
The following are needed to install a Serial
ATA drive to a system. 
• Serial ATA capable motherboard or
controller card
• Serial ATA drive 
• Serial ATA cable (1 meter or less in
length)
Handling precautions
_______________________________________
Set the drive down gently to prevent damage
from impact or vibration.
• Do not open the ESD bag containing the
drive until needed.
• Handle the drive carefully by the edges.
Do not touch the exposed printed circuit
board or any electronic components.
• Do not press on the top or bottom of the
drive.
• Before handling the drive, discharge any
static electricity from yourself and your
clothing. With one hand touch an
unpainted metal surface on your
computer chassis, then touch the ESD
bag with the other hand. Remain in
contact with the chassis and the bag for a
minimum of two seconds.
Page 1
®
E7K500
Quick installation procedure
_______________________________________
Note: Back up all data before installing drive!
1. Turn off the computer.
2. Unplug the computer.
3. Remove the computer cover as instructed
4. Discharge static electricity (see Handling
5. Note the mounting position of existing
6. Remove the drive from the ESD bag.
7. Record the model, the part number, and
8. Attach the Serial ATA cable to the drive.
Connect Power Connector
_____________________________
Connect Serial ATA power connector if
provided on power supply or use legacy 4 pin
power connector. Arrange cable to match
connector as shown in photos below.
by the computer system manual.
precautions).
drives and cables. If you are replacing a
drive or any cable, remove it now.
the serial number of the drive for future
reference.
Match key on cable to connector on drive.
Version 1.1