Table of Contents
Advertisement
setting up your washer
hoW To WASh AuToMATICALLy DePenDS on The LAunDry
Before starting washing, check the following;
•
Connect the water supply hose to the water tap. Leave a tap open. Plug the power cord in. Make sure
to lay down the drain hose.
Washing for the first time
Before washing clothes for the first time, you must run a complete cycle without clothes.
To do this:
1. Press the Power button.
2. Open the detergent drawer and insert a little detergent.
3. Turn on the water supply to the washing machine.
4. Press the Start/Pause button.
This will remove any water from the manufacturer's test run remaining in the machine.
Special notes!
Clothes loading order
• When loading the clothes into this machine ensure the following loading order is used for
maximum washing effectiveness. T shirts, bath towels, table cloths, business shirts, bed
sheets, pillow cases, under shorts, wash cloths then finally handkerchiefs.
Automatic Sensing Function
•
For Fuzzy,Quick,Super clean, Water saving program the amount of laundry is automatically
sensed and then appropriate water level, washing time, rinsing cycle, and spinning time are
automatically selected for automatic washing.
•
After the power is on, a program is selected and Start/Pause button is pressed. Then, the
washing tub starts spinning without water. This action senses how much laundry is in the
washing basket, not a machine problem. After this sensing process, water is then supplied
automatically.
Adding Detergent and Softener
•
It senses the amount of laundry and indicates the water level. Then, it starts water supply
right away.
•
During the water supply, it is possible to open the detergent box and add detergent.
However, it is better to press Start/Pause button to stop water supply and add detergent.
Close the lid and press Start/Pause button again. This way is much more convenient.
(However, during the water saving course, you cannot open the lid.)
•
If the softener is inserted in the softener dispenser, it automatically adds in at the last rinsing
cycle.
Put the laundry into the washer and add detergent
•
Be careful not to overload. Use the right detergent for the fabrics you are washing.
• If the lid is open while running, the washing machine is stopped automatically for safety.
• When hot water is selected, both cold and hot water are supplied for the first 20
• Possible to control the washing time, rinsing cycle, and spinning time at every program
10_setting up your washer
WA13SPW-02817D-01_EN.indd 10
(Except, water supply continues while the lid is open.)
seconds in order to protect the clothes.
during the washing.
2010-10-08
2:22:36
Advertisement
Table of Contents
