Denon AVR-X3500H Service Manual page 101

3-3. Error Code H1-03 failure detection procedure
Checking device. [U1000 : MN864788]
Check the power supply voltage. (HDMI SW2)
Check item(3-3.1.). Check the power supply voltage. :
Does the power supply voltage of the HDMI SW2 [U1000] indicate the correct voltage (1.1V, 3.3V)?
The test points are as follows.
HDMI SW2
112 pin
U1000
1.1V
38 pin
3.3V
YES
Check item(3-3.2.).
Check the power components [U1063/U1066] and the pattern on
the substrate.
If there is no problem, remove the HDMI SW2 [U1000] from the
substrate and measure the voltage at the test point of
(3-3.1.).
Is the voltage correct (1.1V or 3.3V)?
Replace with a new device.
Recheck from
If it does not work, replace the PCB.
NO
Check the power supply voltage. :
check item
YES NO
The power supply circuit is
faulty.
Replace the PCB.
check item (3.1.)
Checking the reset waveform. (HDMI SW2)
Check item(3-3.3.). Checking the reset waveform :
Check the waveform.
Is the "RESET" waveform of the TP near the HDMI SW2 [U1000]
correct (like the one shown in the diagram) when the power is
turned on?
HDMI SW2
RESET
U1000
YES
101
Examples of confirmation waveform
Voltage scale : 1.0V/div
Time scale : 20ms/div
NO
Check the reset circuit between
CPU [U1018] and HDMI SW2
[U1000].
If there is no problem, the HDMI
SW2 [U1000] is faulty.
Replace with a new device.
Recheck from check item (3-3.3.)
If it does not work, replace the
PCB.
Go to next page.