Table of Contents
Advertisement
Click the [click to connect] button to start communication.
After a connection is established successfully, the display of the button name will change as
shown in Figure 4.
Figure 4. Change of the Display of the Communication Start Button Name
TV settings :
Switch to the HDMI input in the AVR connection.
Player settings : Turn the unit power on and configure it to play disks.
AVR settings :
While the power is On, hold down buttons "CURSOR f " and "STATUS" for
at least 3 seconds.
(Continue to press and hold the buttons until all segments of the FLD volume illuminate.)
※ When the power is turned on after initialization, "Setup Assistant" will be displayed.
After exiting "Setup Assistant" execute the above.
Figure 6. AVR settings
Figure 6. FLD Display When Set
Display changes.
Press
All the indicatorLights
When the settings are correct, the following message will be displayed in the window of
Termite.
[00]Start Sub CPU Log Mode
****
(**** is a version of Sub CPU.)
Figure 7. Display of Termite When AVR is Set
The setup is now complete.
Method for sending commands
Enter the command in the transmission command entry section, click the [Send] button and
send the command.
1. Input a command in the
transmission command input.
Figure 8. Method for Sending Termite Commands
105
2.Click on the transmission button.
Hide quick links:
Advertisement
Table of Contents
