Cannot Connect To The Network - Denon AVR-X6300H Service Manual

5. Network / Bluetooth / USB

5.1. Cannot connect to the network

Check the connection environment
Is the LAN cable correctly inserted?
YES
Check the setting
Are the network settings of this unit correct?
YES
Are peripheral devices such as the router and
hub connected to this unit correctly?
YES
Are the router settings correct?
YES
Checking the unit
Can the voltage (5V) be confirmed between pin
2, 3 and pin 4, 5 of N6001?
YES
NO
Insert the LAN cable correctly and then turn on
the power again.
NO
Set the IP address, etc. correctly.
When the static IP address is used, check that no
other devices have the same IP address and that
the subnet mask settings are correct.
NO
Connect the peripheral devices correctly.
NO
Check the instruction manual of the router and
configure the settings correctly.
Check that there are no connection restrictions
by MAC addresses, etc.
NO
The circuit between the AC inlet and N6001 is
faulty.
Check the SMPS PCB.
NO
Can the output voltage (5V)
Is NET5V_POWER (U6201
to Q8007 (FET-SW) be con-
uCOM 48 pin) "Hi" ?
firmed?
YES
NO
Can the output voltage (1.2 V)
Is NET3.3V_POWER (U6201
to Q8009 (FET-SW) be con-
uCOM 135 pin) "Hi" ?
firmed?
YES
85
NO
The circuit of NET5V_POWE
between U6201 and Q8007
are faulty.
YES
The circuit around Q8007
(FET-SW) is faulty.
NO
The circuit of NET3.3V_
POWER between U6201 and
Q8009 are faulty.
YES
The circuit around Q8009
(FET-SW) is faulty.
Go to next page.