Electromagnetic Compatibility - Cisco SOHO Series Regulatory Compliance And Safety Information Manual

Electromagnetic Compatibility

•
•
Agency Approvals and Standards
This section lists the following agency approvals and standards for EMC:
•
•
•
•
•
•
•
•
•
•
•
•
FCC Class B Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
•
•
•
Modification of this equipment without Cisco's authorization may result in this equipment no longer
Caution
complying with FCC requirements for Class B digital devices. In that event, your right to use the
equipment may be limited by FCC regulations, and you may be required to correct any interference to
radio or television communications at your own expense.
Regulatory Compliance and Safety Information for Cisco 800 Series and SOHO Series Routers
4
Australia Compliance Statement
Statement 157—VCCI Compliance for Class B Equipment
CFR47 part 15 subpart B, 2000 class B
EN55022, 1998 class B, CISPR22, 1997 class B
EN55024, 1998 Immunity Std, CISPR24, 1997 Immunity Std
EN61000-3-2, Harmonics, EN61000-3-3, Flicker
EN61000-4-2, Electro Static Discharge
EN61000-4-3, Radiated Immunity
EN61000-4-4, Electrical Fast Transients
EN61000-4-5, Surge
EN61000-4-6, Conducted Immunity
EN61000-4-11, Dips and Sags
AS/NZS 3548
CCC
Reorient or relocate the receiving antenna
Increase the separation between the equipment and the receiver
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
OL-10260-02