Kenmore PG-40409S0LB-COSG User & Care Manual page 7

6. Turn the coupling nut clockwise and tighten to a full
stop. The regulator will seal on the back-check
feature in the LP tank valve, resulting in some
resistance. An additional one-half to three-quarters
turn is required to complete the connection. Tighten
by hand only - do not use tools.
NOTE:
• If you cannot complete the connection, disconnect
regulator and repeat steps 5 and 6. If you are still unable to
complete the connection, do not use this regulator!
• Call for replacement parts at 1-888-287-0735.
DANGER
• Do not insert any tool or foreign object into the valve
outlet or safety relief valve. You may damage the valve
and cause a leak. Leaking propane may result in
explosion, fire, severe personal injury, or death.
WARNING
• Outdoor gas appliance is not intended to be installed
in or on a boat.
• Outdoor gas appliance is not intended to be installed
in or on an RV.
• Never attempt to attach this grill to the self-contained
LP gas system of a camper trailer or motor home.
• Do not use grill until leak-tested.
• If a leak is detected at any time, STOP and call the fire
department.
• If you cannot stop a gas leak, immediately close LP
cylinder valve and call LP gas supplier or your fire
department!
Hold coupling nut and
regulator as shown for proper
connection to LP tank valve.
Leak Testing Valves, Hose and Regulator
1. Turn all grill control knobs to OFF.
2. Be sure regulator is tightly connected to LP tank.
3. Completely open LP tank valve by turning OPD hand wheel
counterclockwise. If you hear a rushing sound, turn gas off
immediately. There is a major leak at the connection. Correct
before proceeding. Call for replacement parts at 1-888-287-
0735.
4. Brush soapy solution onto areas where bubbles are shown in
picture below:
5. If "growing" bubbles appear, there is a leak. Close LP tank
valve immediately and retighten connections. If leaks cannot
be stopped do not try to repair. Call for replacement parts at
1-888-287-0735.
6. Always close LP tank valve after performing leak test by
turning hand wheel clockwise.
7
Never remove threaded
orifice at end of valve