Table of Contents
Advertisement
9 Disassembly and Assembly Instructions
9.1.
Remove the Rear cover
1. See PCB Layout (Section 3)
9.2.
Remove the AC inlet
Caution:
To remove P.C.B. wait 1 minute after power was off for dis-
charge from electrolysis capacitors.
1. Unlock the cable clampers to free the cable.
2. Disconnect the connector (P9).
3. Remove the screws (×2
4. Remove the screw (×1
9.3.
Remove the P-Board
Caution:
To remove P.C.B. wait 1 minute after power was off for dis-
charge from electrolysis capacitors.
1. Unlock the cable clampers to free the cable
2. Disconnect the connectors (P52, P56 and P58).
3. Disconnect the connectors (P2, P6, P11, P34 and P35).
4. Remove the screws (×5
) and remove the Inlet metal.
) and remove the AC inlet.
) and remove the P-Board.
9.4.
Remove the P2-Board
Caution:
To remove P.C.B. wait 1 minute after power was off for dis-
charge from electrolysis capacitors.
1. Unlock the cable clampers to free the cable.
2. Disconnect the connectors (P51, P55 and P57).
3. Disconnect the connector (P9).
4. Remove the screws (×4
23
) and remove the P2-Board.
Advertisement
Table of Contents
