Table of Contents
Advertisement
6
Symbologies
This programming section contains the following menu selections. Refer to
• All Symbologies
• China Post (Hong Kong 2 of 5)
• Codabar
• Code 11
• Code 128
• Code 32 Pharmaceutical (PARAF)
• Code 39
• Code 93
• EAN/JAN-13
• EAN/JAN-8
• GS1 DataBar Expanded
• GS1 DataBar Limited
• GS1 DataBar Omnidirectional
All Symbologies
If you want to decode all the symbologies allowable for your scanner, scan the All Symbologies On code. If on the other hand,
you want to decode only a particular symbology, scan All Symbologies Off followed by the On symbol for that particular sym-
bology.
All Symbologies On
Message Length Description
You are able to set the valid reading length of some of the bar code symbologies. If the data length of the scanned bar code
doesn't match the valid reading length, the scanner will issue an error tone. You may wish to set the same value for minimum
and maximum length to force the scanner to read fixed length bar code data. This helps reduce the chances of a misread.
EXAMPLE:
Decode only those bar codes with a count of 9-20 characters.
Min. length = 09Max. length = 20
EXAMPLE:
Decode only those bar codes with a count of 15 characters.
Min. length = 15Max. length = 15
For a value other than the minimum and maximum message length defaults, scan the bar codes included in the explanation of
the symbology, then scan the digit value of the message length and Save bar codes on the
cover of this manual. The minimum and maximum lengths and the defaults are included with the respective symbologies.
Chapter 8
for settings and defaults.
• GS1 Emulation
• GS1-128
• Interleaved 2 of 5
• Matrix 2 of 5
• MSI
• NEC 2 of 5
• Plessey Code
• Straight 2 of 5 IATA (two-bar start/stop)
• Straight 2 of 5 Industrial (three-bar start/stop)
• Telepen
• Trioptic Code
• UPC-A
• UPC-A/EAN-13 with Extended Coupon Code
• UPC-E0
Programming Chart
All Symbologies Off
inside the back
6 - 1
Advertisement
Table of Contents
