After Finishing Work; Transporting; Storing - Stihl BR 700 Instruction Manual

English
1
2
► Start the engine.
► Use trigger (2) to adjust blowing force.
► Push the Master Control Lever (1) upwards.
This locks the blowing force in that position.
To deactivate the locking gas: Move the Master
Control Lever (1) back to the position .
11.4 Setting to winter mode
The carburetor may ice up if the engine is oper‐
ated at temperatures below + 10 °C. The shutter
must be set to the winter mode
retor is additionally heated by warm air from
around the engine.
NOTICE
■ The engine may overheat if is operated in win‐
ter mode at temperatures above + 10 °C.
► Change setting to summer mode
► Shut off the engine.
2
1
3
► Unscrew the screws (1).
► Remove filter cover (2) and air filter (3).
► Clean the area around the air filter (3) with a
damp cloth or a soft brush.
► Loosen the screw (4).
5
4
12
so that carbu‐
.
4
2
1
3
► Set the flap (5) to the winter mode position .
► Fully tighten the screw (4).
► Insert the air filter (3) and put on the filter
cover (2).
► Insert screws (1) and tighten.

12 After Finishing Work

12.1 When Work is Finished
► Shut off the engine.
► Allow the blower to cool down.
► If the blower is wet: Allow the blower to dry.
► Clean blower.

13 Transporting

13.1 Transporting the blower
► Shut off the engine.
Carrying the blower
► Carry the blower on your back and hold the
blower by the operating handle with your right
hand or carry it by the handle.
Transporting the blower in a vehicle
► Attach the blower to the handle of the back
plate using the Velcro strap.
► Secure the blower in an upright position so
that the blower cannot tip over or move.

14 Storing

14.1 Storing the blower
► Shut off the engine.
► Attach the blower to the handle of the back
plate using the Velcro strap.
12 After Finishing Work
0458-459-0121-E