Cisco SOHO 96 Quick Start Manual page 4

Connect the Router
Follow these steps to connect the router to the power supply, your local network, and your service
provider's network:
If you are connecting more than 4 PCs to the router, connect the router to a switch or hub using
Step 1
a yellow Ethernet cable, as shown in
To connect a PC directly to your router, do so as shown in
Step 2
obtain an IP address from the router when it is turned on. You can connect additional PCs to the
remaining numbered Ethernet ports.
The console port is a service port to which you can connect a terminal or PC in order to configure the
Step 3
software by using the command-line interface (CLI) or to troubleshoot problems with the router. If you
want access to the router console, connect a PC or terminal to the Console port. For more information,
refer to the Cisco 836 and SOHO 96 Hardware Installation Guide.
Optional. For dial backup and remote management, you can connect the ISDN S/T port to a Network
Step 4
Termination (NT1) box or an ADSL splitter' using the orange ISDN S/T cable (ordered separately). For
more information, refer to the Cisco 836 and SOHO 96 Hardware Installation Guide.
Connect the the ADSL cable to the ADSLoISDN port on the router and to the ADSL splitter or wall
Step 5
socket. If you are using an ADSL splitter, connect the splitter to the wall socket using a Category 5
unshielded twisted-pair cable.
Step 6 Connect power to the router as shown in
supply that was shipped with the router.
The device is designed to work with TN power systems.
Warning
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that
Warning
a fuse or circuit breaker no larger than 120 VAC, 15A U.S. (240 VAC, 16A international) is used on the
phase conductors (all current-carrying conductors).
This equipment is intended to be grounded. Ensure that the host is connected to earth ground during
Warning
normal use.
Cisco 836 Router and Cisco SOHO 96 Router Cabling and Setup Quick Start Guide
1-4
Chapter 1 Cisco 836 Router and SOHO 96 Router Cabling and Setup Quick Start Guide
Figure 1-3.
Figure
Figure 1-3 and turn on the router. Be sure to use the power
1-3. Turn the PC off so that it will
78-14767-06