X97; Troubleshooting Of Washer - Singer SISIL SWM-FA70R User Manual

troubleshooting
troubleshooting of Washer
List of faults and corrective actions
faults Corrective actions
if the power is off or the fuse is burned out.
if the water supply is cut off or the water pressure is too low
No water
if the inlet hose is not properly connected and the water tap is opened.
flows in to
if the filtering screen of the inlet value is blocked by dirt.
the washing
if the inlet value is malfunctioned (The slight electromagnetic sound is a normal
machine
phenomenon when the inlet value is switched on)
if the "Start / Pause" button is pressed after the power switch is pressed.
if the power is off or the fuse is burned out.
if the power support voltage is too low.
No washing
if the water amount not reached to the required water level. (The washer will not work
operation is
if the water amount does not reach the required water level)
taking place
if it is set to "Delay" washing mode. (It will only start to work until the reservation time
is reached.)
if the water drain hose is placed very high.
No water
if the end of water drain hose is sealed in pond or gully.
draining out
if the internal rubber ring of the drain value is blocked by dirt
if the door lid is closed.
if the clothes are gathered largely at one side of tub or the load of clothes is
No spinning
excessive.
or abnormal
if the washer is not placed in a stable condition or it is placed in an inclination state.
noise
(The ground is not fat or levelling leg).
if the motor belt is loose.
Is the electric voltage normal?
The power is
cut off.
Is the washer plugged in? Plug in the electric cord.
The water
drains out The drain is clogged with coins or pins.
continuously.
Water does
The drain hose is hung over the drain hose hook.
not drain
If the faucet connection is loose, water may leak.
Check if the rubber packing of the water supply hose is in the right position.
Water leaks
at the water Is the water supply hose damaged?
supply side
If the water supply is too strong, water may leak.
Is water leaking from the faucet itself?
note : During the spinning process, if the clothes are piled at one side of the
spin tub, it will be result in the spin tub being unbalanced and may lead to
the tub striking the cabinet. When this happens, the machine will immediately
detect and correct the imbalance up to three times. If the imbalance is not
resolved by the auto-correction feature of the machine, the user has to
manually re-distribute the clothes inside the tub to solve the problem.
35