Connecting Wintv- Usb To A Sound Card; Connecting Wintv-Usb To A Vcr, Video Camera Or Camcorder - Hauppauge WinTV-USB Installation And Reference Manual

WinTV-USB
Installation and Reference Manual
while recording. To do this, click on the Menu button and go to Audio Type and
select Digital Rec+Live.
Close and reopen the WinTV application to have the changes take
effect.
Connecting the WinTV-USB to a Sound Card
The WinTV-USB can supply audio over the USB bus. If you would like to connect
directly to a set of speakers, a headset, to a stereo system or directly to a sound
card, follow these instructions.
The board's audio output can be connected using the supplied Audio Cable:
- plug one end of the supplied 1/8" Audio Cable into the jack marked
LineOut on the WinTV-USB.
- plug the other end of the Audio Cable into your speakers or headset, or a
soundcard's LineIn jack.
ote: Most sound cards have three round jacks on the outside of
N
the PC. They are: Microphone Input, Audio Output and Line
Input. The Audio Output would go to your speakers, while the
Microphone input might go to a microphone (if you are using one). The
LineIn jack is normally indicated on the sound card by the words IN or
LineIn stamped into the metal bracket on the outside of your PC. This
is where you would plug your Audio Cable, Also Some Laptops do not
have a Line in and you would have to connect the USB device to the
Mic input on the Laptop, or to a seperate set of powered speakers.
Connecting the WinTV-USB to a VCR, Video
Camera or Camcorder
Most VCR's or camcorders have a female RCA jack labeled "Video Out". Most
also have a jack labeled "Audio Out". Most video cameras simply have one out-
put connection labeled "Video Out".
To connect the video to the W W i i n n T T V V - - U U S S B B
with male RCA connectors on both ends:
- connect from the "Video Out" jack on your video camera, VCR or cam-
corder to the S-Video input jack on the WinTV-USB.
1-6
, use shielded video cables (not supplied)