Installing The Manifold - Husqvarna FE 250 2016 Repair Manual

Main work
-
Position the manifold and mount springs
I
Spring hook (50305017000)
-
Mount and tighten screw
Guideline
Remaining screws,
chassis
(FE EU)
-
Connect plug-in connector
route the cable without tension, and secure with a new
cable tie.
-
Install the fuel tank. (0
Lift the rear frame slightly and position the shock absorber.
-
Mount and tighten screw
Guideline
Screw, top M10
shock absorber
-
Position the rear frame.
-
Mount and tighten screws
Guideline
Screw, sub­ M8
frame
CD
-
Remove screws on both sides.
-
Mount and tighten screws
Guideline
Screw, sub­ M8
frame
O.
(0 p. 320)
8.
25 Nm (18.4 lbf ft)
M8
CD
of the lambda sensor,
p. 94)
8.
60 Nm (44.3 lbf ft)
Loctite ®
0
on both sides.
35 Nm (25.8 lbf ft)
®
Loctite
CD
on both sides.
35 Nm (25.8 lbf ft)
Loctite ®
10 EXHAUST
2701
TM
2701
TM
2701
TM
81