Initial Configuration Using The Setup Command Facility - Cisco Router 3600 Hardware Installation Manual

Configuring the Router
If you need help with interface and port numbering, see the
Note

Initial Configuration Using the Setup Command Facility

This section shows how to use the setup command facility to configure a host name for the router, set
passwords, and configure an interface for communication with the management network. If you see the
following messages at the end of the startup sequence, the setup command facility has been invoked
automatically:
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]:
The setup command facility prompts you for basic information about your router and network, and it
creates an initial configuration file.The prompts vary, depending on your router model, the installed
interface modules, and the software image. The following example and the user entries (in
shown as examples only.
For a description of the interface numbering, see the
If you make a mistake while using the setup command facility, you can exit and run the setup command
Note
facility again. Press Ctrl-C, and enter setup at the privileged EXEC mode prompt (Router#).
To proceed using the setup command facility, enter yes when the power-up messages have ended.
Step 1
When the following messages appear, press Return to enter basic management setup:
Step 2
Enter a host name for the router (this example uses 3600):
Step 3
Enter an enable secret password. This password is encrypted (more secure) and cannot be seen when
Step 4
viewing the configuration:
Cisco 3600 Series Routers Hardware Installation Guide
3-54
Would you like to enter the initial configuration dialog? [yes/no]: yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system
Would you like to enter basic management setup? [yes/no]: yes
Configuring global parameters:
Enter host name [Router]:
The enable secret is a password used to protect access to
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.
Enter enable secret: xxxxxx
"Interface Numbering" section on page
"Interface Numbering" section on page
3600
Chapter 3 Installing the Router
1-8.
) are
bold
1-8.
OL-2056-05