Panel Mounting; Figure 9: Panel Mount - GE PACSystems RX3i User Manual

Cep profinet scanner

Hide thumbs Also See for PACSystems RX3i:

Table of Contents

Panel Mounting

For applications requiring maximum or long-term resistance to mechanical vibration and shock, the panel-

mounting method is strongly recommended. A minimum panel thickness of 2.4 mm (.093 in) is required.

The mounting diagram shown in Figure 9 applies to both the CEP001 Carrier and CEE001 Expansion Carrier.

Note 1: Tolerances on all dimensions are ±0.2mm (0.078 inch) non-cumulative.

Note 2: Apply 1.1 to 1.4 Nm (10 to 12 in/lbs) of torque to M3.5 (#6-32) steel screws threaded into

tapped holes in the panel.

GFK-2883E

March 2018

Chapter 3. Installation and Mounting

Table of Contents