Quick Start Connection And Setup - Harman Kardon SIGNATURE 2.0 Service Manual

Signature 2.0 Processor/Tuner

Quick Start Connection and Setup

Connect 75-ohm
FM antenna here
®
NRTL /C
LR110480
CSA E65
FRONT CENTER SURR
L
R
SUB
6-CH DIRECT INPUTS
Connect to analog audio
output of A/V sources,
CD, tuner, etc.
1. Before proceeding, make certain that all equipment, including the 2.0, is unplugged from AC power. This will prevent
any damage due to the unintended activation of automatic turn-on circuits.
2. Use high-quality audio and video interconnect cables to connect your source equipment to the rear of the 2.0 as shown
in the diagram above and the table below. It is important to note that unlike conventional audio/video equipment, the 2.0
does not have inputs that are labeled for connection to a specific type of equipment (e.g., inputs labeled "CD," "Tape" or
"VCR"). Instead, the 2.0 allows you to connect the analog or digital audio and composite or S-Video outputs of your source
equipment to any of the inputs. Then, using the setup procedures detailed on page 28 of this manual, you can custom
configure the input sources. However, for a quick starting point, follow the input suggestions outlined in the chart shown
below. They conform to the preset conditions for the 2.0.
Source
Equipment
Cable Box, Satellite
Receiver, TV Tuner
VCR
DVD
HDTV, Satellite with Digital
Audio, Laser Disc
Tuner (internal)
CD Player
Cassette or Tape Deck
Outboard Decoder
Connect to coaxial
digital audio output
of A/V sources, DVD,
HDTV, CD, etc.
Connect AM loop Connect to optical
antenna here digital audio output
of A/V sources, DVD,
HDTV, CD, etc.
FM AM
1 2 3 4
ANTENNA
DIGITAL AUDIO DATA INPUTS
1 2 3 4 5 6
ANALOG AUDIO INPUTS REC OUTPUTS
Connect to audio
Connect to
input of VCR or
a powered
audio recorders
subwoofer
or subwoofer
amplifier
Remote
Button
TV
Video 1
Video 2
Video 3
Tuner
CD
Tape
Aux
Signature 2.0
Connect to
Connect to output
of composite composite
video sources video input
of VCRs
Connect to
composite
video input of
main monitor
IN OUT
1 2 3
MAIN
5 6
4 5 6
REC
FRONT CENTER SURR
COMPOSITE VIDEO
L
RS-232
R
SUB
AUDIO OUTPUTS
Connect to
inputs of audio
power amplifiers
Video Input
Connection
Analog 2
Analog 1
Digital 1
Digital 2
(Internal Tuner)
Digital 3
Analog 5
6-Ch. Direct Inputs
5
10
harman/kardon
Connect to
S-Video input
of main monitor
Connect AC Power
to non-switched
wall outlet
Connect to
S-Video Connect to
S-Video input
output
sources of VCRs
MODEL NO.: SIGNATURE SERIES 2.0
IN OUT
HARMAN KARDON
1
MAIN
NORTHRIDGE
CALIFORNIA, USA
MADE IN USA
~
115V 60Hz
75 WATTS
SERIAL NUMBER
2
CA UTI ON CA UTI ON
REC
S – VIDEO
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS:
RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR
WARNING:
TO REDUCE THE RISK OF FIRE
IR IR TRIGGER OR ELECTRIC SHOCK DO NOT EXPOSE THIS
EQUIPMENT TO RAIN OR MOISTURE.
IN OUT OUTPUT
Manufactured under license from Dolby Laboratories Licensing
Corporation. "Dolby", "AC-3", "Pro Logic" and the Double-D symbol
are trademarks of Dolby Laboratories Licensing Corporation.
Copyright 1992 Dolby Laboratories, Inc. All rights reserved.
EXTERNAL CONTROLS
Connect to "Trigger
In" jack on Signature
Series or other compatible
power amplifier
Audio Input
Connection
Composite 2
Composite 1
S-Video 1
S-Video 2
Composite 2
N/A
N/A
Composite 1