Advertisement
STEP 2 - Remove the compressor from the unit.
STEP 3 - Prior to setting base plate, install pallet
nuts, bolts and recip bushings onto the base plate.
Secure base plate into compressor compartment.
Note: Corners on provided base plate are cut.
STEP 4 -After securing the compressor to the
mounting plate using new grommets and screws,
slide the crankcase heater around the compressor,
tighten the mounting screw and secure the wires
out of the area that you will be brazing.
Note: Crankcase heater is for heat pump only.
INSTALLER'S GUIDE
Page 3
Advertisement
