Carrier 48FC Installation Instructions

PRODUCT USAGE
Carrier Units
MODEL
48FC
48GC
48HC
48LC
48TC
Bryant Units
MODEL
582K
581K
581J
580J
ICP Units
MODEL
RGV
RGW
RGH 181, 183, 210, 213, 240, 243, 300, 303
RGS 210, 214, 240, 244, 300, 304, 333, 336
NOTE: Not all unit sizes may be available at this time.
PACKAGE CONTENTS
ACCESSORY PART NUMBER
CRFLUEDS006A00
SAFETY CONSIDERATIONS
Installation of this accessory can be hazardous due to system
pressures, electrical components, and equipment location (such as
a roof or elevated structure). Only trained, qualified installers and
service technicians should install, start-up, and service this
equipment.
When installing this accessory, observe precautions in the
literature, labels attached to the equipment, and any other safety
precautions that apply:
• Follow all safety codes
• Wear safety glasses and work gloves
• Use care in handling and installing this accessory
It is important to recognize safety information. This is the safety-
alert symbol: . When you see this symbol on the unit and in
instructions or manuals, be alert to the potential for personal
injury.
Understand the signal words DANGER, WARNING, CAUTION,
and NOTE. These words are used with the safety-alert symbol.
DANGER identifies the most serious hazards which will result in
severe personal injury or death. WARNING signifies hazards
which could result in personal injury or death. CAUTION is used
Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.
Catalog No. 04-53480342-01
Installation Instructions
Part No. CRFLUEDS006A00
UNIT SIZES
20, 24, 28, 30
20, 24, 28
17, 20, 24, 28
14,17, 20, 24, 26
17,18, 20, 21, 24, 25, 28, 29, 30
UNIT SIZES
20, 24, 28, 30
20, 24, 28
17, 20, 24, 28
17, 18, 20, 21, 24, 25, 28, 29, 30
UNIT SIZES
210, 240, 300, 336
210, 240, 300
CONTENTS
Flue Deflector, pre-assembled
Printed in U.S.A. Form IIK-CRFLUEDS06-03 Rev. A
Single Package Rooftop Units
Gas Heating/Electric Cooling
Select 12.5 to 27.5 Ton
Flue Discharge Deflector Accessory
to identify unsafe practices, which may result in minor personal
injury or product and property damage. NOTE is used to highlight
suggestions which will result in enhanced installation, reliability,
or operation.
IMPORTANT: This book contains instructions for the
installation of accessory
CRFLUEDS006A00 on the models and sizes listed in the
Product Usage tables. Do not attempt to install this accessory on
any unit NOT INCLUDED in these tables.
WARNING
ELECTRICAL SHOCK HAZARD
Failure to follow this warning could result in personal injury
and/or death.
Before beginning any modification, close main gas supply
shutoff valve. Be certain that the main line electrical
disconnect switch is in the OFF position and the lockout tag is
installed. Tag disconnect switch and gas valve with suitable
warning labels.
GENERAL
The accessory flue discharge deflector directs unit flue exhaust
vertically instead of horizontally. This allows for a smaller unit
clearance due to flue exhaust.
INSTALLATION
1. Close the manual shutoff valve on the gas supply piping.
2. Shut off power to unit and install lockout tag.
3. Remove existing flue hood from unit. Save screws. (See
Fig. 1.)
4. Align deflector assembly (Fig. 2) with outlet and remove
screw in center post that lines up with upper bracket. Save
screw.
5. Fasten deflector assembly inlet with screws removed in
Step 3 to unit flue outlet. (See Fig. 3.)
6. Align upper bracket with empty screw hole in center post.
Secure with screw removed in Step 4. (See Fig. 3.)
7. Return power to unit and remove lockout tag.
8. Open the manual shutoff valve on the gas supply piping.
SERVICE
Remove and clean the screen periodically to ensure proper airflow
and heating efficiency. Inspect full length of flue stack for any
blockages which could impair flue performance. Inspect every
fall, and periodically during heating season.
Pg 1 5-22
flue deflector assembly
Replaces: IIK-CRFLUEDS06-02