Cisco CISCO1751 Quick Start Manual page 11

If the installer does not start after a few seconds, select Start>Run, and enter d:\setup where d is your
CD-ROM drive.
Step 5 Follow the instructions on the screen to install the Cisco ConfigMaker application.
To learn about the Cisco ConfigMaker application, view the online movie, or use Cisco ConfigMaker
Help Topics from the help menu.
You need administrative privileges to install the Cisco ConfigMaker application on Windows NT.
Cisco IOS Command-Line Interface
To configure your router from the command-line interface (CLI), refer to this guide, the Cisco 1700
Series Software Configuration Guide, or the Cisco 1751 Router Software Configuration Guide available
on the Documentation CD-ROM.
Major Voice over IP Configuration Tasks
Follow these major steps to configure Voice over IP (VoIP) on your router:
Configure your IP network to support real-time voice traffic. Before you move to the next step, ping the
Step 1
remote router to make sure you have an IP connection.
Configure your router to support voice ports. Follow these steps for your specific requirements:
Step 2
•
•
•
Enter configuration mode to configure your router for VoIP traffic. Refer to the
Step 3
Voice-over-IP" section on page
Save the configuration. Refer to the
Step 4
Establish a dial plan to determine how the call can be routed. Use the dial-peer voice command to define
Step 5
dial peers and to implement the dial plan. Refer to the
Fine-tune your network to adequately support VoIP by configuring a series of protocols and features for
Step 6
quality of service (QoS). Refer to the
page
78-11259-05
Foreign exchange station (FXS) and foreign exchange office (FXO) voice ports
The default voice-port values are usually adequate for both FXS and FXO voice ports. However, if
you need to change the default values, refer to the Cisco 1751 Router Software Configuration Guide.
E&M voice port
The default values for an E&M voice port are not sufficient to enable voice and data transmission
over the IP network. E&M values must match those of the connected PBX device. Refer to the
"Connecting the FXS, FXO, and E&M VICs to the Network" section on page
ISDN BRI port
The default values for a basic rate interface (BRI) port are not sufficient to enable voice and data
transmission over the IP network. BRI values must match those of the connected PBX device. Refer
to the "Connecting the FXS, FXO, and E&M VICs to the Network" section on page
25.
10.
"Saving the Configuration" section on page
"Dial Plan" section on page
"Tuning Parameters for Real-Time Voice Traffic" section on
Cisco 1751 Voice-over-IP Quick Start Guide
Configuring Voice-over-IP
4.
4.
"Configuring
13.
14.
11