This cooktop is for use with natural gas and universal lpg (11 pages)
Summary of Contents for Bosch PBH615B9TA
Page 1
This cooktop is for use with Natural Gas and Universal LPG Leave this instructions with the owner PBH615B9TA USER INSTRUCTIONS INSTALLATION INSTRUCTIONS MAINTENANCE INSTRUCTIONS GMK10047...
Converting the cooktop from Nat. Gas to Universal LPG ...5 Changing the nozzles of the burners on the cooktop ....5 Additional information on products, accessories, replacement Adjustment of the taps...............5 parts and services can be found at www.bosch-home.com and in the online shop www.bosch-eshop.com Safety considerations For your safety For pressure testing in excess of 3.5 kPa (1/2 psig) the...
Note: To avoid jeopardising the electrical safety of the SHOULD THE RELEVANT CONDITIONS NOT BE PROPERLY appliance, it is forbidden to use high-pressure or steam jet SATISFIED, THE INSTALLER, AND NOT THE cleaning devices. MANUFACTURER, SHALL BE HELD LIABLE. Installation Statutory requirements Preparing to install Refer to AS/NZS 5601.1 for piping size details.
Clearances For cutout dimensions and clearances see Preparing to install. Installation procedure: A range hood fitted above the top must be installed according to the installation instructions for the range hood. A minimum The clips and the adhesive seal (underside of the cooktop) are distance of 650 mm is required for a range hood and 750 mm already fitted (depending on the model), do not under any for an exhaust fan.
Converting the cooktop from Nat. Gas to Universal LPG During the planning stage, consider the position of supply connections. To change injectors The cooktop must be connected to the gas supply with All work involved in installation, setting and adaptation to a upstream connection of an isolation valve in accordance with different gas type must be carried out by authorised personnel the respectively valid regulations.
To adjust the minimum flame for N.G. replace the control knob It is important that all the seals are refitted to form a seal. onto the spindle, light the gas and turn the control knob to the Never remove the tap spindle. In the event of a malfunction, small flame position.
Operation To ensure that this device is active: Remove the plastic covering used to protect the stainless steel Switch on the burner as usual. before using the appliance (depending on the model). If any Without releasing the control knob, press and hold it down traces of adhesive remain on the printed areas, remove them firmly for 4 seconds after lighting the flame.
Important: Do not use damaged pans, The use of a cooktop leads to the production of heat and which do not sit evenly on the moisture in the kitchen. For this reason make sure that the hob. Pans may tip over. room is properly ventilated.
Service DO NOT MODIFY THIS APPLIANCE. Sometimes certain faults detected can be easily resolved. Before calling the Technical Assistance Service, bear in mind Only authorized personnel from the Service Centre are qualified the following advice: to work on the appliance. Fault Possible cause Solution...