Harman Kardon HK3475 Owner's Manual page 5

Main Power Switch
System Power Control
Power Indicator
Headphone Jack
Mute
Speaker 1 Selector
Speaker 2 Selector
Phono Input Selector
T-Mon (Tape Monitor) Input Selector
Main Power Switch: Press this button to apply
power to the HK 3475. When the switch is pressed in,
the unit is placed in a Standby mode, as indicated by
the Power Indicator surrounding the System
Power Control . This button MUST be pressed in
to operate the unit. To turn the unit off and prevent the
use of the remote control, this switch should be
pressed until it pops out from the front panel so that the
word "OFF" may be read at the top of the switch.
NOTE: In normal operation this switch is left in the
"ON" position.
System Power Control: When the Main Power
Switch is "ON, " press this button to turn on the
HK 3475; press it again to turn the unit off. The Power
Indicator surrounding the switch will initially turn
red as the HK 3475 performs a self-check, and it will
change to green when the unit is on and ready for use.
Power Indicator: This LED will light in amber
when the unit is in the Standby mode to signal that the
unit is ready to be turned on. When the unit is turned
on, the indicator will briefly turn red, and then change
27 26
HK 3475
MUTE T-MON
Tuning Button
Tape Input Selector
Preset Scan
CD Input Selector
Aux Input Selector
Preset Selector
VMAx Selector
FM/AM Selector
FM Mode Selector
to green. A red indicator during normal operation
means that the unit is in the Protect mode, and should
be turned off and then checked for a possible speaker-
wire short circuit.
Headphone Jack: This jack may be used to listen
to the HK 3475's output through a pair of headphones.
Be certain that the headphones have a standard 1⁄4"
stereo phone plug.
Mute: Press this button to momentarily silence the
speaker output of the HK 3475.
Speaker 1 Button: Press this button to turn
the speakers connected to the Speaker 1 Output
Terminals ‡ on or off.
Speaker 2 Button: Press this button to turn
the speakers connected to the Speaker 2 Output
Terminals ° on or off.
Phono Input Selector: Press this button to
select the output of a turntable that is connected
to the Phono Inputs §.
25
AUTO TUNED ST MEMORY PRESET
SLEEP
VMAx
VMAx
Sleep Button
Bass Control
Treble Control
Balance Control
Volume Control
Volume/Mute Indicator
Main Information Display
Speaker Selection Indicators
Remote Sensor Window
T-Mon (Tape Monitor) Input Selector: Press
this button to listen to the output of a tape recorder
connected to the Tape Monitor Inputs ª. The
T-Mon indicator will light to indicate that the input
source is being monitored when the HK 3475 is
connected to a three-head tape deck or another unit
with off-head playback.
Tuning Button: Press the left side of the button to
tune lower-frequency stations and the right side of the
button to tune higher-frequency stations. When a station
with a strong signal is tuned, the Tuned Indicator
will light in the Main Information Display
(1/2 second) press of the button will manually tune to
the next frequency increment, while pressing and hold-
ing the button for a longer period will automatically
tune to the next station with a signal strong enough for
acceptable reception.
Tape Input Selector: Press this button to listen to
the output of a tape recorder or other device connected
to the Tape 2 Inputs ⁄.
24 23
21
20 22
. A brief