Harman Kardon HK3390 Owner's Manual page 9

Remote Control Functions
The remote is capable of operating the HK 3490/
HK 3390 and most Harman Kardon CD changers
or players, CD Recorders and Tape decks, using
the control codes that are part of the remote.
å Main Power On: When the HK 3490/
HK 3390 is in the Standby mode, as indicated by
the Power Indicator 3 glowing amber, press this
button to turn the HK 3490/HK 3390 on.
∫ Main Power Off: When the HK 3490/
HK 3390 is turned on, press this button to place it
in the Standby mode. Note that in this condition,
the unit is still connected to AC Power.
ç Source Selectors: Press these buttons to
select an input source for the HK 3490/HK 3390.
NOTE: The first press of the Video 3 Source
Selector ç will select the device connected to the
rear-panel Video 3 Audio/Video Inputs
the Video 3 Source Selector ç again until the
display reads VIDEO F / ANALOG to select the device
connected to the front-panel Video 3 Audio/Video
Inputs 1. Each additional press of the Video 3
Source Selector ç will toggle between the front-
and rear-panel Video 3 Audio/Video Inputs
1.
∂ Preset Up/Down: When the tuner is in use,
these buttons scroll through the stations that
have been programmed into the HK 3490/
HK 3390's memory. These buttons also control the
track Skip Up and Down on compatible
Harman Kardon compact disc players/changers,
CD-Recorders and cassette decks (with that func-
tion).
≠ Transport Controls: These buttons are used to
control Play, Play Forward, Play Reverse, Stop, Pause
and Record functions on compatible Harman Kardon
compact disc players/changers and cassette tape
decks. Also, when a compatible Harman Kardon
compact disc player or changer, or cassette deck,
has been selected using the Source Selectors
ç, additional transport control functions are
available using the Preset Up/Down ∂ but-
tons.
ƒ Menu Navigation Buttons: Use these but-
tons to move Up, Down, Left or Right when using
the Menu system of the HK 3490/HK 3390.
© Sleep Button: Press this button to place the
unit in the Sleep mode. Each press of the button
selects the amount of time that will remain before
the unit will automatically go into the Standby
mode, as shown in the Main Infor mation
Display Û, in the following order:
90 80 70 60
min min min min
40 30 20 10
min min min min
Holding the button pressed for some seconds will
directly turn off the Sleep time selection.
˙ Dimmer Button: Press this button once to
reduce the brightness of the front panel display to
half the normal intensity and turn off the light
inside the Volume Button. Press it again to turn
the front panel display completely off. When the
display is completely off, press the button to return
to normal brightness.
î Main Tuning Buttons: When the tuner is in
use, these buttons will tune up or down through
the selected frequency band. A brief press of the
button will manually tune to the next frequency
increment, while pressing and holding the button
for a longer period (>0.5 sec) will step quickly
through the frequencies. As soon as the button is
released the unit will automatically tune to the
next station with a signal strong enough for accep -
table reception.
Δ Direct Button: Press this button to select a
. Press
radio station by entering its frequency using the
Numeric Keys. (See page 13 for more informa-
tion.)
K Numeric Keys: These buttons serve as a ten-
button numeric keypad to enter tuner preset posi-
tions or track numbers with CD players/changers
or to tune stations directly.
¬ Auto Preset: When the tuner and FM band
have been selected, this button may be used to
automatically program the tuner presets for all
stations with acceptable signal strength. To start
the auto preset scan, press and hold the button.
Keep holding the button pressed until the tuner
will start to "look" for stations, as shown by
increasing frequency numbers in the Infor mation
Display. Release the button and note that the
tuner will search the entire FM band and stop
briefly at each station that has acceptable signal
strength. The HK 3490/HK 3390 will automatical-
ly assign a preset number to each station and
then search for the next station. If the FM tuner
finds fewer than 30 FM stations with acceptable
signal strength, the Auto Preset tuning will scan
two more cycles or until the remaining vacant
preset memory spaces have been filled with those
found in the first scan. The scan will stop when all
30 preset memory spaces have been filled or
when three scans through the band have been
completed (See page 13 for more information).
μ Menu Button: When using a H/K DVD player
with the receiver, you can activate the DVD Menu
with this button.
Ñ Clear Button: This button is used to clear pre-
set memory inf or mation for the HK 3490/
HK 3390's tuner. (See page 13 for more informa-
50
tion on tuner presets.)
min
OFF ø Memory Button: Press this button to open a
memory position that stores a preset location for
the HK 3490/HK 3390's tuner. (See page13 for
more information on tuner presets.)
π Master Volume: Press these buttons to raise
or lower the HK 3490/HK 3390's volume.
œ P. Scan Button: Press this button to automat-
ically scan through the list of stations that are pro-
grammed into the HK 3490/HK 3390's tuner mem-
ory. When the button is pressed, each preset sta-
tion will play for five seconds before the next sta-
tion is selected. Press the button again when the
desired station is heard to stop the preset scan.
® Mute Button: Press this button to momen -
tarily silence the HK 3490/HK 3390.
ß FM Mode Button: Press this button when
the tuner is in use in the FM band to switch to
monaural reception if the stereo station is weak
and noisy. (See page12 for more information.)
† Search Forward / Search Reverse
Buttons: When using a H/K CD-player or DVD-
player, use these buttons to fast search in either
direction.
ü Speaker 1 Selector: Press this button to turn
the speakers connected to the Speaker 1 Output
terminals on or off.
√ Speaker 2 Selector: Press this button to turn
the speakers connected to the Speaker 2 Output
terminals on or off.
∑ Transmitter Window: Point this area of the
remote toward the receiver when using the
remote.
≈ OK Button: This button has no function on
the HK 3490/HK 3390, but may be used as the
Enter key for a compatible Harman Kardon DVD
Player or as the Random Play button for a compati-
ble CD Player. (See page 16 for more information
on using the remote to control other devices.)
¥ RDS Display Button: Press this button to
view the various displays of the RDS options that
are available when a station is transmitting RDS
data. (See page 14 for more information on RDS
tuning.)
Ω RDS PTY Button: Press this button to start a
search for a specific PTY type using the RDS capa-
bilities of the HK 3490/HK 3390. (See page 14 for
more information on RDS tuning.)
a DSP Mode Button. (HK 3490 only): This
Button switches between the Digital Sound
Processor Modes. Press to activate the Dolby
Virtual Surround function. Press repeatedly to tog-
gle between STEREO, Dolby Virtual Surround-
WIDE and Dolby Virtual Surround-REF. See page
12 for explanation of DVS.
b Disc Menu Button: Displays the actual DVD
Disc Menu on the TV screen in Play Mode.
REMOTE CONTROL FUNCTIONS 9