HK 3370 Stereo Receiver Introduction Safety Information Unpacking Front Panel Controls Rear Panel Connections Remote Control Functions Installation and Connections Operation Basic Operation Source Selection Tuner Operation Tape Recording Memory Backup Processor Reset Troubleshooting Guide Technical Specifications Typographical Conventions In order to help you use this manual with the remote control, front-panel controls and rear-panel connections, certain conventions have been used.
While sophisticated systems are hard at work If you have any questions about the voltage within the HK 3370 to make all of this happen, The HK 3370’s powerful amplifier uses requirements for your specific model, or about hookup and operation are simple.
Safety Information Do Not Open the Cabinet Avoid moist or humid locations. This device complies with Part 15 of the FCC There are no user-serviceable components Rules. Operation is subject to the following two Do not obstruct the ventilation slots on the inside this product.
Main Power Switch 1 is “ON, ” press this to apply power to the HK 3370. When the used to listen to the HK 3370’s output through a switch is pressed in, the unit is placed in a button to turn on the HK 3370; press it again pair of headphones.
Page 6
Ú Volume/Mute Indicator: This indicator to indicate that the input source is being brightness after the unit is turned off, then on will glow green when the HK 3370 is turned monitored when the HK 3370 is connected to again.
Rear Panel Connections ¡ LOOP ™ S P E A K E R 1 ( 8 O h m s ) (120V, 60Hz) AC 120V 60HZ RIGHT LEFT £ PHONO TAPE MON. TAPE 2 MAIN IN PRE OUT SUB OUT 400W ¢...
Page 8
When the receiver is turned jacks to the Rec/In jacks of a second audio off, or placed in the Standby mode, power to ¢ Remote IR In: If the HK 3370’s front recorder. these outlets is removed.
Page 10
¬ Auto Preset: When the tuner and FM when the tuner is in use in the FM band to ∫ Main Power Off: When the HK 3370 is band have been selected, this button may be switch to monaural reception if the station is...
Tape Monitor that are in a second room location, to the fine, multistrand copper with a gauge of 14 or Out jacks ‚ on the HK 3370. When the tape Speaker 2 terminals °. smaller. Remember that in specifying cable, the deck connected to these jacks is a three-head lower the number, the thicker the cable.
Page 12
AC Power Connections To optimize the sound field, or to suit your lis- The Accessory Outlets · receive power The HK 3370 is designed for flexible use with tening room environment, you may find that external control components and power ampli- as long as the receiver is turned on.
• When using the HK 3370 for the first time, it 30-position memory. • To temporarily silence all speaker outputs is necessary to press the Main Power button press the Mute button ®...
To reset and briefly hold the Auto Preset button L Information Display will flash, and the actual the system, first turn the HK 3370 off by press- until the MEMO and PRESET indicators begin preset number will disappear from the display.
This unit is designed for trouble-free operation. Most problems users encounter are due to operating errors. So, if you have a problem, first check this list for a possible solution. If the problem persists, consult your authorized Harman Kardon Service Center.