Removing A Card Slide-Assistance Arm - Cisco Carrier Routing System CRS-1 Installation Manual

Chapter 4 Installing and Removing SFCs, RPs, MSCs, FPs, LSPs, PLIMs, and Associated Components
How to Remove or Install a Card Slide-Assistance Arm (Handle)
Figure 4-8 Modular Services Card (CRS-MSC) with Slide-Assistance Arm Attached

Removing a Card Slide-Assistance Arm

This section describes how to remove a slide-assistance arm (handle) from a line card, PLIM, or RP card.
For details about installing or removing the cards themselves, see the "How to Install or Remove an
MSC, FP, or LSP" section on page 4-32, the "How to Install or Remove a PCMCIA Card" section on
page 4-51, and the "How to Install or Remove a Physical Layer Interface Module" section on page 4-42.
Cisco CRS Carrier Routing System 4-Slot Line Card Chassis Installation Guide
4-12
OL-10971-10