Toshiba SD-V340SC Service Manual page 11

Playback (VCR)
Convenience function
Repeat playback
The entire video tape will play until its end. The tape will
automatically rewind to the beginning and the playback will be
repeated.
1
Press VCR MENU.
Press SET + or – to select "AUTO
REPEAT".
MENU
TIMER REC SET
AUTO REPEAT ON OFF
SAP ON OFF
CH SETUP
SYSTEM SETUP
+/Ð/ENTER/MENU
2 Press ENTER to select "ON" or "OFF".
If "ON" is selected, the playback
will be repeated endlessly.
MENU
TIMER REC SET
AUTO REPEAT ON OFF
SAP ON OFF
CH SETUP
SYSTEM SETUP
+/Ð/ENTER/MENU
3
Press VCR MENU until the menu screen is
cleared.
To confirm whether AUTO REPEAT
function is turning ON or OFF, press
CALL. If " " is displayed, it is
turning ON 11 .
4
To commence playback, press PLAY.
The playback will be repeated
endlessly.
To cancel repeat mode:
Follow the above step 1, then press ENTER to select
"OFF" position. Press VCR MENU to return to the TV.
32
Recording (VCR)
Recording a TV program
Recording and viewing the same TV program.
Recording a TV program
Preparation:
• Turn ON the TV and select to the corresponding
video input.
• Press VCR DVD selector to select the VCR mode.
(The VCR mode indicator will light.)
1 Load a cassette tape with the erase prevention
tab intact.
The DVD/VCR will automatically turn on.
2
Press SP/SLP to select the desired tape speed
SP or SLP.
The tape counter and "SP" or "SLP"
will appear on the screen for about 4
seconds.
00 : 00 : 00 SP
3 Select "TV" or "CABLE" to the appropriate
position .
27
TV - VHF/UHF channels
CABLE - Cable TV channels
34
CLOCK/COUNTER
VCR MENU
SET +/–
ENTER
STOP
PLAY
CALL
ZERO RETURN
COUNTER RESET
Zero return function
This function rewinds the tape to the "00:00" counter position
automatically.
1
Press CLOCK/COUNTER.
The counter display shows the tape run-
ning time during playback or recording.
2
Press COUNTER RESET at the desired tape
position.
The counter display will be reset to
"00:00" position (e.g. the beginning of
recording).
3 Press STOP when playback or recording is
completed.
Press ZERO RETURN.
The tape will automatically rewind or fast
forward to the "00:00" counter position.
JUMP
VCR DVD
CH +/–
REC/OTR
SP/SLP
0–9
4 Press Number buttons or CH +/– to select the
channel to be recorded.
+0
TV mode direct channel selection:
All channels can be instantly selected by using two
buttons. (for example, to select channel 2, press "0", then
"2". If you press only "2", channel selection will be delayed
for two seconds.) For channels 10 and above, press the 2
digits in order.
CABLE mode direct channel selection:
1-9 Press 0 twice and then 1-9 as required.
Example: To select "2", Press 002.
10-12 Press 0 first and then the remaining 2 digits in
order from left to right.
Example: Press 012 for "12".
13-99 Press 2 digits in order.
Example: Press 22 for "22".
100-125 Press the 3 digits in order.
Example: Press 110 for "110".
VHF/UHF/CABLE TV CHANNELS
TV CABLE TV
VHF VHF
2-13 2-13
UHF STD/HRC/IRC
14-69 14-36 (A) (W)
37-59 (AA) (WW)
60-85 (AAA) (ZZZ)
86-94 (86) (94)
95-99 (A-5) (A-1)
100-125 (100) (125)
01 (5A)
5
Press REC/OTR.
" " will appear on the screen for
about 4 seconds and "REC" will
appear on the display window.
CH 110
INDEX
Clock/counter display
This function enables you to locate the beginning of any recording
Press CLOCK/COUNTER. The clock and tape counter
made on the VCR.
alternate with each other in the display window.
COUNTER
CLOCK
Press VCR DVD selector. The DVD mode and the
VCR mode alternate with each other in the display.
DVD mode
VCR mode
Notes:
• When you record an INDEX mark at the very beginning of the
• During INDEX search, the tape may stop and begin to play at
Notes:
• If you rewind the tape beyond "00:00", a minus sign ("–") will
be displayed in front of the time. • INDEX may not function properly with old or worn out video
• When you load a tape, the counter will reset to "00:00".
• The counter does not function on non-recorded (blank)
• INDEX marks may not be found if it is extremely close to the
sections of the tape. When you rewind, fast forward or play
tapes through blank sections, the counter stops.
• During recording, if you stop recording temporarily, the INDEX
To stop recording
Press STOP to stop recording.
" " will appear on screen for about
4 seconds.
To stop recording temporarily
Press PAUSE/STEP to avoid recording unwanted
material. Press again to continue the recording.
" " will appear on screen for
about 4 seconds.
Notes:
• The pause function will be released after 5 minutes to prevent
damage to the tape or the VCR. The VCR will change to the
STOP mode.
• You can select a recording channel in the recording pause
mode.
Auto Rewind feature
This VCR will automatically rewind the tape when the tape
has ended (except during OTR and timer recording). It will
also eject the tape.
VCR DVD
CLOCK/COUNTER
STOP
INDEX + / –
Video index search system
Recording an INDEX mark
CH 001
The Index Search function auto-
matically records an INDEX mark
on the tape whenever a recording
INDEX
is initiated.
Index search
Press INDEX + or – during stop or play mode.
For Succeeding programs: Press INDEX +.
For Preceding programs: Press INDEX –.
(As many as 9 index points can be accessed via this
method.)
When the INDEX + or – is
pressed, the unit starts search-
ing the selected INDEX NO. and
finds the portion. Then playback
starts automatically. To stop the
Index Search, press STOP.
or is displayed
INDEX NO. (up to 9)
tape, the mark may not be found.
a slightly different location.
tapes.
point where the search began.
mark is not recorded on the tape.
SQPB (S-VHS Quasi Playback)
You can playback video cassette tapes recorded in the
S-VHS system.
However, the picture will not have the high resolution of
S-VHS system.
Note: You cannot record S-VHS video format with this
VCR.
33
TV/VCR
PAUSE/STEP
STOP
Recording one program while
watching another
While the VCR is recording, select your desired channel
on the TV.
When a TV is connected with an antenna cable only,
press TV/VCR to select the TV position.
The "VCR" display will go off and recording will continue.
Select the TV channel you want to watch by using the
TV channel selector.
Note:
Some Cable TV hookups do not permit viewing one channel
while recording another. See pages and .
16 17
35