Connecting To The Mains Water Supply - Baumatic BD696SS Instruction Manual

o Open the door of the dishwasher and then fix it to the housing
unit, using the four screws provided. These should be screwed
through the dishwasher cabinet and into the housing unit. These
screws must be fully tightened.

Connecting to the mains water supply

IMPORTANT: Do not connect the appliance to your mains
water supply using an old or an existing water inlet hose.
The inlet hose supplied with the dishwasher is the ONLY one
that should be us
DO NOT CONNECT THE WATER INLET HOSE TO A HOT
WATER TAP.
o The inlet hose will be located inside the cabinet of the
dishwasher.
o Connect the inlet hose to the inlet valve on the rear of the
product. Please refer to the photographs above to see the
correct position that the inlet hose should be in when connected.
o Connect the water inlet hose to a threaded water tap that has a
3/4" thread.
o Fully tighten the inlet hose to the water tap and the dishwasher.
Minimum water pressure- 50KPa (0.5 bar)
Maximum water pressure- 1MPa (10 bar)
ed.
IMPORTANT: The inlet hose
is fitted with an aqua stop.
This MUST be fitted in the
upright position, as shown
in
Otherwise
will not operate correctly.
the above diagram.
the appliance
39