Table of Contents
Advertisement
4 INSTALLATION
4.1. General warnings
The reading of this chapter assumes, in order to use the printer safely, the knowledge of the contents of paragraph
1.6 "General safety warnings".
Furthermore, the specific requirements for safe interaction with the printer, related to this chapter, are detailed
in the following paragraphs.
ATTENTION:
The operations related to these activities must be performed by authorized and professionally
qualified personnel.
ATTENTION:
During operations, the operator must wear all the necessary Personal Protective Equipment (PPE).
ATTENTION:
A thermal magnetic protection device must be inserted upstream of the system.
4.1.1. Placement
The printer must be installed in a suitable place, ie such as to allow normal operations of the printer, ordinary and
extraordinary maintenance.
The installation site must not contain any kind of contaminants, dust, fumes, mists, etc.
It is therefore necessary to prepare the necessary operating space by referring to the dimensions (expressed in
mm) given in paragraph 2.4 "Technical data".
The room must also be:
Equipped with the appropriate power supply line;
Installed in environments with brightness equivalent to that expected for industrial environments; as indicated
by the regulations in force in the country of destination, with regard to safety in the workplace. Lighting must not
cause visual disturbance on the transparent part of the door. The lighting must guarantee a perfect reading of the
information given by the display.
The printer must be positioned on a stable and horizontal plane having a capacity suitable for the weight to be
supported. Any unevenness must be included in the construction regulations.
The printer must be placed in an environment with foundations that prevent the transmission of environmental
vibrations.
ATTENTION:
Do not place the printer near sources of heat, water or other free liquids.
Do not install the printer without the appropriate protections.
NOTE:
A good installation as well as giving greater rigidity to the printer, avoids vibrations and noises.
© WASP S.r.l.
Installation
INTRODUCTION
31
4
4
Advertisement
Table of Contents
