IBT Technologies IB791 User Manual page 43

OnChip EHCI Controller
By default, the EHCI (Enhanced Host Controller Interface) Controller is
enabled.
Keyboard Support
By default, the EHCI (Enhanced Host Controller Interface) Controller is
enabled.
SuperIO Device
Onboard FDD Controller
Select Enabled if your system has a floppy disk controller installed on
the board and you wish to use it. If you install an add-in FDC or the
system has no floppy drive, select Disabled in this field. This option
allows you to select the onboard FDD port.
Onboard Serial/Parallel Port
These fields allow you to select the onboard serial and parallel ports and
their addresses.
UART 2 Mode
UART Mode Select enables you to select the in-frared communication
protocol.
Parallel Port Mode
This field allows you to determine parallel port mode function.
SPP
EPP
ECP
Init Display First
This field allows the system to initialize first the VGA card on chip or
the display on the PCI Slot. By default, the PCI Slot VGA is initialized
first.
Standard Printer Port
Enhanced Parallel Port
Extended Capabilities Port
IB791 User' s Manual
BIOS SETUP
39