Making Network Connections - Cisco 3660 Installation Manual

Making Network Connections

Figure 4-8
Connect the other end of the ground lug wire to a grounding point at your site.
Step 5
Making Network Connections
If you still need to install network modules or WAN interface cards, you can do so now. For
Note
instructions, see these publications: Cisco 3600 Series Hardware Installation Guide, Cisco Network
Modules Hardware Installation Guide, Cisco WAN Interface Cards Hardware Installation Guide.
You can access these documents online and on the documentation CD-ROM that you received with
your router
Access Routers > Cisco 3600 Series Routers > Hardware installation documents for Cisco 3600
series
Reinstall network cables and turn ON power to the router.
Note The shielded cables in your NEBS/ETSI kit replace the cables originally shipped with your router.
NEBS/ETSI Intrabuilding Lightning Requirement
Caution
This equipment is suitable for connection to intrabuilding or nonexposed wiring or cabling only. This
cabling must be shielded.
NEBS Level 3 and ETSI Compliance Kit Installation Guide for Cisco 3620, Cisco 3640, and Cisco 3660 Routers
4-6
Ground Lug Fastened to Cisco 3660 Chassis
VOICE
2V
VIC
FXS
V1
1
SEE MANUAL BEFORE INSTALLAT
0
ION
SERIAL
4T
SERIA L 3
SERIA L 2
SERIA L 1
SERIA L 0
CN/LP RXC
RXD TXC TXD
CN/LP RXC
RXD TXC TXD
CN/LP RXC
RXD TXC TXD
CN/LP RXC
RXD TXC
Ground lug
at: Cisco Product Documentation > Access Servers and Access Routers > Modular
HIGH SPEED SERIAL
1HSSI
V0
H
EN
ETHERNE T
4E
ETH 3
ETH 2
ETH 1
ETH 0
3 2 1
0
LINK
EN
ACT
TXD
Chapter 4 Installation on Cisco 3660 Routers
78-5450-06 B0