Install The Water Inlet Hose - Haier XQBM20-E User Manual

Install the water inlet hose

Confirm the water faucet
1. Insert a new flat washer into the end of the inlet hoses. Firmly put the
washers in the coupling.
Note:
You may have to use pliers to tighten the coupling. Do not over tighten
because you may cause damage to the valve.
2. Connect the water inlet hose to the water taps.
3. Connect the other ends to their respective washer inlets located at the
rear of the washer.
4. Check connection between the adapter of water inlet pipe and water faucet.
1)Slightly move water pipe to check whether is secured.
2)Except for the device,open water faucet to check water leakage.
3)Test and ensure that the connecting matter is indeed normal,then can use
normally.
4)Don't fold water pipe improperly.
5)Check connection between adapter of water inlet pipe and water faucet
before using to avoid water drip due to improper usage of the device.
.
.
Nut of the water inlet hose
Water absorption cushion
Jointer of the water inlet valve
Before Using
Before Using
5