Table of Contents
Advertisement
Advertisement
Table of Contents
Summary of Contents for Telmann TEL35D
-
Page 2: Important Safeguards
Important Safeguards To reduce the risk of fire, electric shock or injury when using electrical appliances, please follow these basic safety precautions: FOR YOUR SAFETY Read all instructions carefully, even if you are familiar with the appliance. This appliance is not intended for use by children or infirm persons without supervision. -
Page 3: Name Of Components
Name of Components... -
Page 4: Operating Your Dryer
Operating your Dryer Electrical Requirements Connect the unit to a standard earthed three pin outlet. The power supply must be 220-240V. Loading the Dryer Ensure that items do not contain combustible materials or foreign objects (pins, coins etc.) Turn items with zippers inside out and fasten buckles. -
Page 5: Control Panel Functions
Control Panel Functions Temperature Selector Button Select ‘Heavy’ for items that are particularly bulky or large quantities. elect ‘Delicate’ for materials like Silk, Nylon, Linen etc. Drying Timer Dial There are five drying combinations available: Cool, Anti-wrinkle, Warm, Hot and Air Dry. -
Page 6: Installation Instructions
* A minimum 50mm is needed between the top of the dryer and the ceiling for ease of installation. * If mounting above a washing machine, allow sufficient room to open the lid of the washer. Tools Required For Plaster/ Drill &... -
Page 7: Maintenance
Maintenance Wall Mounting Instructions Cleaning the Lint Filter Unplug the power cord prior to any cleaning. The lint filter must be cleaned before and after each use. Never use the dryer without the filter in place. 1. Removing the Filters Insert fingers into the four holes around the exhaust vent shroud and pull out to remove. -
Page 8: Troubleshooting
Maintenance Cleaning of the Air Intake Filter The filter should be cleaned once a month. Hold the upper and lower edges of the air intake shroud, push upwards gently with your thumb to disconnect the latch hook then pull outwards to remove. Remove the filter from the shroud and clean it with a soft brush and refit.