Setting Up Set A - Dukane 8959A User Manual

Setting up Set A

1.
Turn on Set A.
2.
Set the lens position to the upper limit with the VERTICAL adjuster.
NOTE • If it is not set to the upper limit, the image of Set B may not
superimpose well enough to the image of Set A.
• Perform the INSTALLATION setting first if necessary as it may change the
image position.
• HORIZONTAL adjuster is recommended to be set near the center position.
3.
Adjust the image of Set A to fit the screen with the VERTICAL adjuster,
HORIZONTAL adjuster, ZOOM ring and FOCUS ring.
→
cise) Displaying the
Adjust the image position using KEYSTONE and PERFECT FIT if necessary.
(Operating Guide
• Do not adjust ZOOM ring to the widest position, otherwise the
NOTE
image of Set B may not superimpose well enough to the image of Set A. Fine
adjusting the image position of Set B electrically does not increase its image
size. Use the ZOOM ring to adjust the image size of Set B to slightly larger
than Set A.
• KEYSTONE cannot be operated when PERFECT FIT is in use. To adjust
the image using both KEYSTONE and PERFECT FIT, adjust KEYSTONE
first.
• If you are using Simple Stack, go to
B). ( 11 )
4.
Display the menu with the MENU button.
menu function)
5.
Use the ▲/▼/◄/► buttons to go into the following menu.
ADVANCED MENU > OPTION
> SERVICE > COMMUNICATION
> STACK
STACK menu will appear on screen.
(Operating Guide
(continued on next page)
(Operating Guide
picture)
→
EASY MENU
→
OPTION
→ SETUP menu)
or
SETUP menu)
2.3 Installing the second projector (Set
(Operating Guide
menu)
9
Installation
(User's Manual (con-
→ Using the