Service Adjustments - Sanyo CE28H1A-C-00 Service Manual

SERVICE ADJUSTMENTS

Note: Some items of the service adjustments for this chassis are controlled by the CPU, IC801, and the
adjustments are carried out by using the RC handset.
[After replacing the Memory IC (IC802)]
The memory IC, IC802, stores the service adjustments data for each circuit, therefore, when the memory IC is
replaced, it should be readjusted the following adjustments and confirmed initial data value, refer to the adjustment
table on next page.
Adjustments
Stereo separation adjustment
Vertical Centring
Vertical Height
Horizontal Centring
Horizontal Width
White Balance
DCS Gain
Auto Setup Option setting
Enter to the Service Mode
Press and hold the Function button on the RC handset and then press the Prog + button on the TV set.
ADJUST DATA
+000 K1 +001
+001 K2 -006
+003 STID +000
+ To select the adjustment item, use the Prog+ or Prog- button. The selected item is indicated in red.
+ To change the service data, use the Level - or Level + button.
+ The data which is set in the service mode is stored into the memory IC automatically.
Exit from the Service Mode
Turn off the TV set by using the Mains switch.
Service Manual EH1 chassis
Service Mode
Item 000, Item 001
Item 005
Item 006
Item 009
Item 010
Item 034, Item 035
Item 057
Item 069
Item
+000 K1
+001 K2
+003 STID
-9-
ADJUST DATA
service data
+001
-006
+000