Table of Contents
Advertisement
Setup Files
3
Press the UP/ON button to store the file. To abort
the save operation, press the DOWN/OFF button
(the screen returns to the screen shown in step 2).
The tape automatically rewinds and recording
starts.
The display changes as shown below, which
includes color bars. ("CAN NOT WRITE"
appears on the screen if no tape is loaded or if the
loaded tape is write-protected.)
P A G E 1 2 ( N E X T m$ P R E V m4)
F I L E S T O R E
F I L E : * F I L M L I K E
mD E S T I N A T I O N F I L E
T A P E
E X I T M E N U ( Y E S m4)
After the settings are stored, the following display
appears.
P A G E 1 2 ( N E X T m$ P R E V m4)
F I L E S T O R E
F I L E : * F I L M L I K E
D E S T I N A T I O N F I L E
T A P E
mS T O R E F I L E ?
D O N E
E X I T M E N U ( Y E S m4)
66
Chapter 4 Viewfinder Screen Indications and Menus
Using SetupNavi and SetupLog with the DSR-1/1P
The SetupNavi function records the setup menu and
setup files onto a tape, so that the same settings can be
called up and used again or copied to another camera.
The SetupLog function records a camera settings every
few seconds at shooting and displays the recorded data
in the viewfinder during playback.
Setting up the camera Using
Data Recorded on Tape
The procedure to replace camera's menu settings with
settings recorded onto video tape is described here.
1
Connect the DSR-1/1P and insert the cassette onto
which the data was recorded. Set the POWER
switch to ON while holding down the UP/ON
button.
Advanced menu page 1 appears.
P A G E 1 ( N E X T m$ P R E V m4)
mALL RESET
( Y E S m4)
E X I T M E N U ( Y E S m4)
2
Repeatedly press down on the MENU/STATUS
switch until advanced menu 13 appears.
For details of menu operation, see "Advanced Menu
Operations" (page 57).
PAGE13(NEXT m$ PREVm4)
SETUP NAVI
TAPEmCAMERA
mRECALL DATA
(YESm4)
EXIT MENU (YES m4)
"NO TAPE" is displayed if you neglected to load a
cassette.
3
Press the UP/ON button.
The following display appears.
PAGE13(NEXTm$ PREVm4)
SETUP NAVI
TAPEmCAMERA
mSURE TO RECAL?
(YESm4)
EXIT MENU (YESm4)
4
Press the UP/ON button to call up the data
recorded on the tape. (Press the DOWN/OFF
button to cancel).
The display changes as follows and the call up
operation begins.
PAGE13(NEXTm$ PREVm4)
SETUP NAVI
TAPEmCAMERA
mCANCEL TO RECAL?
(YESm$)
SETUP NAVI
Name of data
MY FILE
being called up
EXIT MENU (YESm4)
To abort the call up operation while in progress
Press the DOWN/OFF button.
After the data has been read, the following display
appears.
PAGE13(NEXTm$ PREVm4)
SETUP NAVI
TAPEmCAMERA
mRECALL DATA
DONE
EXIT MENU (YESm4)
The previous menu settings are overwritten by the
data recorded on the tape.
5
Change the menu settings if necessary.
67
Chapter 4 Viewfinder Screen Indications and Menus
Advertisement
Table of Contents
