Table of Contents
Advertisement
10 Camera Functions
10.1
Save and load the camera settings
The camera has the camera setting save function, and camera setting including factory default loads
function.
The camera has below two type of camera settings.
Default: The factory default settings (This setting cannot change)
User Set X: Over writeable camera settings (X: 0 to 7)
These camera settings load from ROM to register in RAM on camera, and camera settings at register in RAM
on camera save to ROM.
The camera settings saving and loading are controllable with Parameters ("User Set Selector", "User Set
Default Selector"), and commands ("User Set Load", "User Set Save") in "User Set Control" category of
GenICam.
The details of the parameters and the functions are in the table below:
GenICam Parameters
UserSetSelector
UserSetLoad
UserSetSave
UserSetDefaultSelector
Saving Camera Settings
Camera
Settings
Selector
User Set Selector
Setting Procedure
1. Selects "User Set X" at "User Set Selector"
2. Execute "User Set Save"
STC-MBE132POE / STC-MCE132POE
Product Specifications and User's Guide
IEnumeration Type
Select "Default" or "User Set X"
"User Set Load" or "User Set Save" process for selected settings.
ICommand Type
The camera settings load from ROM to register in RAM.
ICommand Type
The camera settings at register in RAM save to ROM.
IEnumeration Type
Select which settings ("Default" or "User Set X") load automatically when
camera power is on. This selection saves automatically.
ROM
User Set 0 to 7
ROM
Default
When executing "User Set Save",
camera settings at the register in RAM are
saved to the ROM that is selected at
"User Set Selector".
Caution:
"User Set Save" CANNOT execute when
"Default" was selected at "User Set Selector"
No.19S185-01
33/68
Advertisement
Table of Contents
