Table of Contents
Advertisement
NOTICE: It is normal for steel appliances to make expansion/
contraction noises as they heat up or cool down. Similar noises
are found with your furnace or car engine.
It is normal for your gas fireplace to give off some odor the first
time it is burned. This is due to the curing of the paint and any
oil from the manufacturing process. If odor becomes offensive,
open windows.
Burn the fireplace for at least six hours the first time you use
it. Keep the fan in the "OFF" mode during this time.
NOTICE: Turn off the gas before servicing appliance.
Have a qualified service person perform the following
(inspections) at the beginning of each heating season:
•
Check Vent System
Inspect the fireplace and venting system before initial use and
at least annually. Inspect the external vent cap on a regular
basis to make sure no debris is interferes with the air flow.
•
Clean Burner and Control Compartment
Keep the control compartment, logs, and burner areas surrounding
the logs clean by vacuuming or brushing at least twice a year.
•
Cleaning Procedure
1.
Turn off pilot light using your remote. Allow the fireplace
to cool completely.
2.
Remove barrier screen and glass front. See page 12.
3.
Remove all logs and coals. Place them in a safe location.
4.
Vacuum burner compartment.
5.
Replace glowing embers, logs, and coals.
6.
Re-install glass front and barrier screen.
7.
Ignite pilot. See page 10.
8.
Operate the pilot burner. If it appears abnormal contact
your dealer for service.
Cleaning the Glass
Clean the glass periodically. We recommend gas fireplace glass
cleaner. During start-up, condensation forms on the inside of the
glass causing lint, dust and other airborne particles to cling to the
glass. Also initial paint curing may deposit a film on the glass. Allow
the fireplace to cool and then clean the glass two or three times with
gas fireplace glass cleaner or a non-abrasive household cleaner
and warm water. After that, clean the glass two or three times during
each heating season or more often if necessary.
Clean glass with cleaner designed for fireplaces.
Do not use Ammonia based or abrasive cleaners on glass.
Do not attempt to clean glass when glass is hot.
Wiring
If any of the original wire supplied with this unit must be replaced,
order from an Empire dealer.
Restore Communication Between Remote Transmitter
and Fireplace Insert
1.
Press remote sync button to the right of the insert.
See Figure 30.
2.
Press the ON button on remote transmitter. An audible
four beeps will be heard.
38101-1-0318
MAINTENANCE AND SERVICE
WARNING
Glass - General Information
Do not operate appliance with the glass front removed,
cracked, or broken.
1.
Avoid breaking the glass.
2.
Do not operate this appliance without the glass front
or with a broken glass front. Have a qualified service
person replace damaged glass and gasket using materials
specified by Empire Comfort Systems.
3.
Do not abuse or strike the glass.
4.
The use of substitute glass will void all product warranties.
Replace Batteries In Remote Transmitter
1.
Locate the cover on the base of the remote transmitter.
2.
Remove the cover and replace existing batteries with three
AAA batteries.
3.
Replace cover. See Figure 31.
Replace Batteries In Backup Pack
Remove glass front and barrier screen (see glass and barrier
screen removal). Locate backup pack on right side of insert. Pull
it up to get access to its cover. Using Phillips head screwdriver
remove cover and existing batteries. Replace with four AA
batteries. Reinstall cover and tighten screw with screwdriver.
SYNC
Figure 30
BUTTON
WARNING
WARNING
Figure 31
Page 11
Advertisement
Table of Contents
