Table of Contents
Advertisement
Preparing the Thermo Recorder
１ １ １ １ １ . . . . .
Install the Battery
①Using a coin, turn the battery cover lock as shown in figure 1 to open cover.
《FIGURE 1 Backside of Main Unit》
②Install Lithium Battery (CR2) as shown in figure 2.
●
Use only new batteries.
●
Make sure the battery is in the right direction.
《Backside of Main Unit》
③Turn the cover lock in the opposite direction of figure 1 to close cover.
２ ２ ２ ２ ２
. . . . . Connect the Sensor
①To connect the sensor, loosen the screws of the channel to be connected.
Channel 2
Channel 1
《Backside of Unit Sensor Connection Terminal》
Screw
②Connect Sensor to Terminal, making sure to follow directions on the sticker on
the backside of unit.（See figure below）
Channel 2
Channel 1
《Sensor Connection Terminal》
【Sensor Wiring Figure】
●
Usually all three wired platinum resistance sensors are wired as in
the figure below. Terminals are represented with the letters A / B or
color red / white.
（
A
red
（
B
white
S
（
B
white
③After connecting the sensor, tighten the screws to prevent slipping.
３ ３ ３ ３ ３
. . . . . Turn Power On
The back up power function ensures no data loss even if the power switch is
●
turned OFF.
《Sticker on Backside》
A
B
B
）
（
A
red
）
（
B
white
）
（
B
white
）
）
）
12
Advertisement
Table of Contents
