Table of Contents
Advertisement
Preparation before Usage
1.Remove all packing material, including foam base, all tapes used
to fasten the annex.
2.Check annex and data: check the articles in the box according to
the "packing list".
3.Before usage, clean the product, for detail refers to "clean" part.
4.Foot adjustment ： Adjust the foot according to the ground
situation to make the product stable so as to lessen shock and
noise.
5.Stewing：After being moved, the product should be stewing for
more than 30 minutes, and then the power can be connected.
6.Connect to power：Make a trial operation after connecting to
power, if obvious cooling down can be felt after one hour, it means
the cabinet is in normal operation.
7. Thru-hole pin：There is a thru-hole pin in the data-bag. When
being used for the first time, it should be placed in the water outlet.
In the using process, the water outlet should be straightway to
allow the frost melting water flow into the water box inside the
engine chamber through the water outlet. When being blocked,
the thru-hole pin inside the water outlet should be taken out,
being cleaned and then put into original place.
Attention：Thru-hole pin should not be used as a too to clean
the water outlet, and can only be placed inside the water outlet
to avoid the block of the water outlet.
Advertisement
Table of Contents
