Table of Contents
Advertisement
1.7.2 When performing hardware debugging with target system
Caution Before turning on the power of the target system, make sure that the power of the IE-703002-MC
is turned on.
If the target system is turned on while the IE-703002-MC is off, the target system or the IE-703002-
MC may be damaged.
(1)
Connect interface board to PC
Before connecting, make sure that the power of the PC is off.
(2)
Set clock operation mode of IE-703002-MC
The IE-703002-MC is provided with a 6.667 MHz crystal oscillator at factory shipping.
The clock setting differs depending on the option board used.
For details, refer to the user's manual of the option board used.
(3)
Set illegal access detection ROM
Switch the illegal access detection ROM.
(For details, refer to the user's manual of the option board used.)
(4)
Set jumpers to adapt to voltage range of CPU
and target system
Set jumpers to adapt to voltage range of CPU and target system
(For details, refer to the user's manual of the option board used.)
(5)
Connect cables
Connect power source adapter and interface cable.
(6)
Connect IE-703002-MC to target system
(7)
Power up IE-703002-MC, then PC, then target
system
22
CHAPTER 1 OVERVIEW
3.1 Connection to Personal Computer
2.2 Clock Setting
2.3 Setting of Illegal Access Detection ROM
2.4 Operating Voltage Setting
3.3 Cable Connections
3.2 Connection to Target System
3.4 System Power-on and Power-off
User's Manual U11595EJ5V0UM
Advertisement
Table of Contents
