When Installing Into The Pvm-L5 Series Video Monitors - Sony BKM-143HS Operation Manual

When installing into the PVM-L5
series video monitors
The BKM-143HS can be installed in the input option slots
located on the rear panel of the video monitor. You can
install one BKM-143HS only.
Notes
• The M Board of the video monitor must be replaced with
the one supplied with the BKM-143HS. Consult your
Sony service personnel for the replacement.
• You cannot use the BKM-155DV after the replacement
of the M Board.
• Be sure to turn off the video monitor and unplug the AC
power cord before installing or removing adaptors.
1
Remove the covers of two input option slots on the rear
panel of your video monitor.
Covers of the
input option
slots
2
Insert the BKM-143HS into the slots.
3
Push the BKM-143HS in until it is firmly seated in the
connector inside the video monitor.
4
Tighten the four screws to retain the BKM-143HS.
After installation, select an input signal. (See page 18 and
19.)
17
Installing into Video Monitors