Close-Up View (Interrior) - Haier WQP12-ABM User Manual

Close-up View (Interrior)

A Upper Rack
B Rack Height Adjustor
C
Top Sprayer Arm
D
Lower Rack
Technical characteristics
Width
Depth
Height
Capacity
Mains water pressure
Power voltage
Total absorber power
E
Washing Filter
F Bottom Sprayer Arm
G Detergent and Rinse Aid Dispenser
H
Salt Container Cap
I
Third Sprayer
mm.600
mm.570
mm.820
12 standard place settings
0.03-0.6MPa
220-240V~
2100W
S a l t
Salt
The hardness of the water varies from place
to place. If hard water is used in the
dishwasher,desposits will form on the dishes
and utensils.
The appliance is equipped with a special soft-
ener that uses a salt specifically designed to
eliminate lime and minerals from the water.
Loading the Salt into the Softener
Always use salt intended for use with
dishwashers.
The salt container is located beneath the lower
rack and should be filled as follows:
- Remove the lower rack and then unscew
and remove the cap from the salt container;
- If you are filling the container for the first time,
fill it with water;
- Place the end of the funnel(supplied) into the
hole and introduce about 2 kg of salt.It is
normal for a small amount of water to come
out of the salt container.
- Carefully screw the cap back on.
The salt container must be filled when the "low
salt" indicator light (located on the control panel),
comes on. .
To prevent the formation of rust,load the salt
just before begining a wash cycle.
Adjusting Salt Consumption
The dishwasher is designed to allow for ad-
justing the amount of salt consumed based
on the hardness of the water used.This is
intened to optimize and customize the level of
salt consumption so that it remains at a
minimum.
To adjust salt consumption,proceed as follows:
- Unscrew the cap from the salt container;
- There is a ring on the container with an ar-
row on it (see figure to the side),
- If necessary, rotate the ring in the
anticlockwise direction from the "-" setting to-
wards the "+" sign,based on the hardness of
the water being used.
It is recommended that adjustments be made
in accordance with the following scheme:
Water Hardness
Salt
Selector
Clarke
dH c o n s u m p t i o n
mmol/l
position
detergent
(Grams/cycle)
0 14
Autonomy
(cycles\2kg)