Turing On The Appliance; Wash Cycle Adjustment Buttons; Energy Saving Tips - Haier WQP12-ABM User Manual

Turing on the Appliance

Starting a wash cycle
- Make sure that the plug for the appliance
is inserted into the wall socket.
- Make sure that the water supply is turned
on to full pressure.
- Load the dishwasher (see the section
entitled,"Loading the Dishwasher").
- Pour in the detergent (see the section
entitled,"Salt,Dergent and Rinse Aid").
- Turn the knob located on the right of the
control panel in the clockwise direction
until the number or symbol for the cycle
setting is aligned with the reference mark
(see the section entitled,"Wash Cycle Table").
- Press the ON-OFF button,and the ON-OFF
light will turn on.At this point,the wash cycle
will begin.
If you forget to load some of the
dishes
The wash cycle can be interrupted by pressing
the ON-OFF button.You can then load addi-
tional dishes and turn the appliance back on.
The cycle will start where it left off.
At the end of the wash cycle
When the knob stops turning and is aligned
with a STOP mark(see figure),the cycle has
finished.Turn off the appliance using the ON-
OFF button,turn off the water supply and open
the door of thr dishwasher.
Wait a few minutes before unloading the dish-
washer to avoid handling the dishes and uten-
sils while they are still hot and more suscep-
tible to breakage.They will also dry better.
STOP
Cancelling or modifying a wash cycle
setting
Premise:A cycle that is underway can only be
modified if it has only been running for a short
time.Otherwise, the detergent may have al-
ready been used,and the appliance may have
already drained the wash water,If this is the
case,the detergent dispenser must be refilled
(see the paragraph entitled,"Loading the
Detergent").
Press the ON-OFF button,and the ON light
will turn off.Rotate the knob in the clockwise
direction to the desired cycle setting(see the
section entitled.:Starting a wash cycle

Wash Cycle adjustment Buttons

Button
This button(see "close-up View - Control
Panel",letter"G")is used for normally dirty
dishes, pots and pans.It is standard daily cycle.
1/2 load Button
This button(see "close-up View - Control
Panel",letter"H") make it possible to wash
dishes using only the upper rack if there are
not enough dishes for a full load.This will al-
low you to save on water and eletrical energy.

Energy Saving Tips

It is important to try and run the dishwasher
-
when it is fully loaded to save on enery.In
order to prevent odors from forming and food
from caking onto the dishes,you can run the
hold cycle.
- Choose the right wash cycle: the choice of
cycle depends on the type of dishware, cook
ware and utensils being washed and how dirty
they are.
It can be used before setting any of the wash
cycles, except for the intensive cycles (if in-
cluded in the wash cycle table ). Please keep
in mind that the amount of degertent should also
be cut in half.
Rapid button
This button(see "close-up View - Control Panel",
letter "I") ,when pressed with wash cycle 4
(glassware) make it possible to run the wash
cycle at a lower temperature (50
eliminates the drying phase.
- Use the right amount of detergent: if you use
too much detergent, the result will not be
cleaner dishes,but,rather,a greater negative
impact on the enviroment.
- There is no untility in rinsing dishes ,cook
ware and untensils before placing them in the
dishwasher.
) and