Show Command Descriptions And Examples - Cisco Network Device 7010 Replacement Instructions Manual

Replacing the Chassis

show Command Descriptions and Examples

This section describes the various show commands that you can use to display system status and
configuration. If you installed the interface processors in the same slot locations that they occupied
in the old chassis, the interfaces should retain the same configuration. If you installed the interface
processors in different slot locations, the system will recognize the interfaces, but you will have to
use the configure command to reconfigure and enable them.
The show version command displays the current hardware configuration of the router, including the
system software version that is currently loaded and running. The show controllers cxbus command
lists all CxBus interfaces and includes the currently loaded and running microcode version for each.
You can check the version of the default ROM image either by removing the board and checking the
ROM labels or by configuring the interface or system software to boot from ROM, restarting the
system, and using these same commands to check the running version.
Use the show version command to display the current system software version, and use the show
controllers cxbus command to display the microcode version of the SP and each interface
processor. In the following example of the show version command, the running system software is
Release 10.3(1)).
Following is an example of the show controller cxbus command display. (In this example, ROM
Version 1.0 is assumed because you cannot determine the ROM version with screen displays unless
it is the running version.)
20 Cisco 7010 and Cisco 7505 Chassis Replacement Instructions
Router> show version
GS Software (GS7), Version 10.3(3), SOFTWARE
Copyright (c) 1986-1995 by cisco Systems, Inc.
Compiled Wed 10-May-95 14:46 by mpo
System Bootstrap, Version 4.6(1) [fc2], SOFTWARE
Current date and time is Sat 1-22-1994 21:38:35
Boot date and time is Tue 12-28-1993 15:32:28
Router uptime is 3 weeks, 4 days, 6 hours, 7 minutes
System restarted by reload
System image file is "gs7-k.103-1", booted via tftp from 1.1.1.12
(example text omitted
X.25 software, Version 2.0, NET2 and BFE compliant.
Bridging software.
1 EIP controller (6 Ethernet).
1 TRIP controller (4 Token Ring).
6 Ethernet/IEEE 802.3 interfaces.
4 Token Ring/IEEE 802.5 interfaces.
(remainder of example text omitted)
Router# show controllers cxbus
(text omitted from example)
FSIP 1, hardware version 1.0, microcode version 1.0
Interface 8 - Serial1/0, electrical interface is V.35 DTE
(text omitted from example)
Interface 9 - Serial1/1, electrical interface is V.35 DTE
(remainder of displayed text omitted from example)