Panasonic ER-GP30 Operating Instructions Manual page 10

Cleaning
• Clean the clipper and the blade after each use.
(If not cleaned, the motion will become poor and the sharpness
will worsen.)
• Make sure that the clipper is turned off.
1. Brush off any hairs from the
clipper and from around the
blade.
2. Brush off the hairs from the
blade edge.
3. Brush the hairs out from between
the stationary blade and the
moving blade while pressing
down on the cleaning lever (a)
to raise the moving blade.
10
Lubrication
• Apply the oil to the clipper before and after each use.
Apply a drop of the oil to each
indicated point.
Attach the blade to the main
body, turn on the power and
allow to run for approximately
5 seconds.
Failure to apply the oil may
cause the following problems
due to rust, wear or burn out.
- The clipper has become blunt.
- Shorter operating time.
- Louder sound.
► Replacement parts
Replacement part is available at your dealer or Service Centre
Replacement parts for ER‑GP30

Blade WER9701