Front And Rear Grille Installation; Operating Instructions - Pelonis PFS40M2ABB User Manual

FRONT AND REAR GRILLE INSTALLATION

Fig.7
Buckle
Grill line
1. Align the front grille buckle with the top line of the rear grille from
top to bottom, after aligning, the grilles should look like the
corresponding schematic.(Fig.7)
2. Press the grilles with both hands in sequence, and while the grilles
are being connected, you will hear several clicks.(Fig.8)
3. For self-locking installation, tighten the screw (separate screw driver
needed) on the lower grille buckle of the front grille.(Fig.9)

OPERATING INSTRUCTIONS

1. Speed is controlled by the rotary knob located on top of the motor
housing:
0---Off 1---Low 2---Medium 3---High
2. To start/stop the fan head oscillation, push down/pull up the clutch
knob that is located on the top of the motor housing.
3. To adjust the air flow upward or downward, push the grilles lightly
to the desired direction.
4. The height of the fan can be adjusted by loosening the height
adjustment ring, carefully carefully raising or lowering the fan and
firmly re-tightening the height adjustment ring.
Fig.8
Grill line Buckle
1 1
2 2
3 3
Fig.9
Grill buckle
 Page 7 