Page 1
WINDOW TYPE ROOM AIR CONDITIONER OPERATION MANUAL Model: HW-18CV03 Please read this operation manual before using the air conditioner. No. 0010557109...
Operation Guide Operation panel Auto swing switch Temp. setting Mode selection Auto swing HIGH HIGH COOL COOL COOL COOL WAIT THREE MINUTES BEFORE RESTARTING Thermostat switch Mode selection switch...
Page 6
When mode selection switch is shifted to "HIGH FAN" or"LOW FAN", air-con will only blow out air without cooling. While the air conditioner running, its mode selection shouldn't be shifted frequently between "HIGH FAN" and "HIGH COOL", "LOW FAN" and "LOW COOL".
Page 7
COOL COOL Operate the switch as follows: Temp. decreases as the switch is turned from "1" to "10". Temp. increases as the switch is turned from "10" to "1".
Maintenance NOTE: Always unplug the air conditioner before servicing or moving it. When dirt accumulates on air filter, air circulation will be blocked, which causes poor cooling. It is advisable to clean air filter every two weeks for longer operation.
Page 9
Maintenance Disposal of condensate The drain hole on the bottom of the air conditioner will be clogged by a rubber stopper to make the condensate in the bottom tray be spattered onto the condensation to raise efficiency of heat exchange. If the spattering sound disturbs you, you can adopt the method illustrated below.
Set temp. a little bit higher before going to bed. Don't be exposed to cold air for a long time. Keep heat source away from air conditioner. Keep away from me After unit stops, don't restart it until 3 min. have elapsed. OK! enjoy a...
Cautions Don't hang clothes in the vicinity of air inlet. This will decrease cooling effect and cause abnormal operation. G o a w a y ! For longer and trouble-free operation of the unit, pay special attention to the following: Install air-con at a place strong enough to support the unit.
Trouble Shooting Phenomenon Is plug firmly inserted? Doesn't work Does fuse get burned? Is there power? Is thermostat switch wrongly adjusted? Is direct sunlight in the room? Is mode selection switch set to "HIGH FAN" or No cool air or "LOW FAN"? poor cooling Is door or window left...
Installation instruction Selection of the installation position 1. Select position where the structure is firm. 2. Select position where the air inlet and outlet are smooth without obstacles. 3. Select position where the cooled air can be blown to every corner. 4.
Page 14
3. Take the air conditioner and its attach- ments out from the packing carton. 4. Let the rear of the air conditioner raise slightly, the drain hole on the bottom can be seen. Clog it with a black rubber stopper attached to the air conditioner (see Fig.2).
Page 15
9. Air conditioner being fixed,insert the power plug in the socket, open the operation panel cover, turn the temperaure setting to "Test run", turn successively the mode selection to "Hi fan"...