Advertisement
7. If the oil level is low, open the top plug (C) and fill the
oil through the top plug hole. Fill the oil slowly until
oil comes out from the level hole. Refer to
data on page 107 .
8. Install the level plug and the top plug.
To do a check of the quantity of grease
in the grease cartridge in the breaker
grease pump (DXR 145)
1. Park the product on level ground and stop the
To stop the product (DXR 145) on
product. Refer to
page 62 .
78
2. Examine the quantity of grease in the grease
cartridge. The grease cartridge is empty when the
Technical
plastic sleeve is at the end stop
C
.
3. If the grease cartridge is empty, do the procedure
that follows.
a) Clean the area around the grease cartridge and
the breaker grease pump. This prevents
contamination of the breaker grease pump
system.
b) Remove the grease cartridge from the breaker
grease pump.
c) Cut the plastic cover from the new grease
cartridge.
d) Install a new grease cartridge in the breaker
grease pump.
1401 - 002 - 15.10.2021
Advertisement
