Connect The Router - Cisco 850 Series Quick Start Manual

Access routers cabling and setup
Hide thumbs Also See for 850 Series:
Table of Contents

Advertisement

Chapter 1
Cisco 850 Series and Cisco 870 Series Access Routers Cabling and Setup Quick Start Guide

Connect the Router

Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Cisco 850 Series and Cisco 870 Series Access Routers Cabling and Setup Quick Start Guide
78-16262-04
Connect the router, referring to the typical installation for your router model as
shown in the
"Typical Installations of the Cisco 850 Series and Cisco 870 Series
Routers" section on page
Follow these steps to connect the router to the power supply, to your local
network, and to your service provider:
Wireless models only: Make sure that you have attached the antennas to the router
as described in the
"Connect the Antenna to the Wireless Router (Optional)"
section on page
1-8.
If you are using a PoE module, make sure that it is connected to the router (see
"Connect the Power-over-Ethernet Module to the Cisco 870 Series Router
(Optional)" section on page
module, not to the router.
If you are connecting more than four PCs to the router, connect the router to a
switch or hub by using a yellow Ethernet cable, as shown in
Figure
1-9.
Connect a PC directly to your router, as shown in
Turn off the PC so that it will obtain an IP address from the router when it is turned
on. You can connect additional PCs to the remaining numbered Ethernet ports.
The console port is a service port to which you can connect a terminal or PC in
order to configure the software by using the command-line interface (CLI) or to
troubleshoot problems with the router. If you need access to the router console,
connect a PC or terminal to the console port.
By connecting the console port to an asynchronous modem using the
Note
optional router modem cable, you can add dial backup and remote
management capabilities to the router.
Cisco 851 and Cisco 871 routers only: Connect the second yellow Ethernet cable
between the router Ethernet WAN port and an available port on an installed digital
subscriber line (DSL), cable, or long-reach Ethernet modem as shown in
Figure
1-6.
1-12.
1-10). Connect the Ethernet devices to the PoE
Connect the Router
Figure 1-6
Figure 1-6
through
Figure
through
1-9.
1-17

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

870 series

Table of Contents