Table of Contents
Advertisement
Follow these steps to install the Content Engine on a workbench or tabletop:
Remove any debris and dust from the tabletop or workbench, as well as from the surrounding area. Also
Step 1
make sure that your path between the Content Engine and its new location is unobstructed.
Attach the rubber feet to the bottom of the chassis. The rubber feet have an adhesive backing. Peel the
Step 2
protective tape off the adhesive and stick the feet to the bottom of a clean chassis surface. Place one foot
in each corner.
Place the chassis on the tabletop or workbench.
Step 3
Ensure that no exhaust air from other equipment is being drawn into the chassis. Also, ensure that there
Step 4
is adequate clearance at the front and rear of the chassis.
Connecting Cables
Follow these steps to connect network, console, and SCSI cables to your Content Engine.
The SCSI cable is part of the Cisco Storage Array accessory kit. If you did not order the Cisco
Note
Storage Array, you did not receive a SCSI cable.
For network connections, insert a Category 5 UTP cable into the Ethernet 1 or Ethernet 2 receptacle on
Step 1
the Content Engine back panel. (See
Connect the other end of the network cable to a hub or switch in your network.
Step 2
For console connections, plug the serial cable into the serial port on the Content Engine back panel.
Step 3
Connect the other end of the console cable to a console or a communications server.
Step 4
If you are using a Cisco Storage Array as an external storage device, attach the SCSI cable to the SCSI
Step 5
LVD port.
Make sure to tighten the jackscrews on the SCSI cable.
Caution
Connect the other end of the SCSI cable to the appropriate port on your Storage Array.
Step 6
For further information about the Cisco Storage Array, refer to the Cisco Storage Array Installation and
Configuration Guide publications.
Connecting Power and Booting the System
Follow these steps to connect power to your AC system:
Step 1
Review the information in the
Plug the AC power cord into the power cord receptacle at the back of the Content Engine. (See
Step 2
78-14731-02
Figure
2.)
"Safety Guidelines" section on page
Installing the Cisco Content Engine 510 and 565
Connecting Cables
10.
Figure
2.)
19
Advertisement
Table of Contents
